CRMX2 Update – March 2024
This is an update to the LumenRadio CRMX chip that is inside our DMG Lighting fixtures. This update will enable Rosco DMG Lighting fixtures to be used within the expanded universes that are available via CRMX2. The firmware and instruction buttons below are for the DMG MINI, SL1, and MAXI fixtures only. DMG DASH w/ CRMX fixtures can be updated to CRMX2 by updating the fixture’s firmware via the myMIX™ app.
Note: The CRMX2 Update only applies to the CRMX chip and does not impact the fixture’s firmware in any other way.
DMG Lighting MIX® Firmware
|
Upgrading to MIX 2.1
UPDATE THE LIGHT
There are two ways to update the MIX Firmware to 2.1: via PC or the myMIX™ app.
Updating via PC (Requires Windows 10 or higher)
Download the Firmware 2.1 Upgrade Utility and the Upgrade Procedure document below.
Follow the instructions in the upgrade procedure to install the driver on your PC and update the fixture’s controller.
Once the driver is installed on your PC, updating each controller only takes a matter of seconds.
Updating the firmware with myMIX
Make sure your myMIX APP is up to date or Download the APP using the links below:
The myMIX app is capable of updating a maximum of 4 lights at the same time.
Updating 1 to 4 lights will take between 20 to 60 minutes.